Sheet Metal Modeling Part #1
Opening a New File
Constructing the Base Flange
Sheet Metal>Base Flange/Tab 
on the CommandManager
PropertyManager>Direction 1>Depth = 150
Use gauge table>sample table - aluminium - metric units
Sheet Metal Parameters>Gauge 14> Bend radius = 2
Adding an Edge flange
Sheet Metal > Edge Flange 
PropertyManager>Flange Length>Length = 100
Flange Length > Inner Virtual Sharp 
Flange Position > Material Outside 
Constructing the Milter Flange
Sheet Metal > Milter Flange 
. 
Milter Flange > Flange Position > Material Inside
> Gap distance = 1.25
Start/End Offset > Start Offset Distance > End Offset Distance = 10
Closing the Corners
Sheet Metal > Corners > Closed Corners 
PropertyManager > Corner type to Butt 
Rotate and select the other corner faces
Adding Corner Reliefs
Sheet Metal > Corners > Corner Relief 
PropertyManager > Corners > Collect all corners
Relief Options > Relief type Circular 
Slot Width = 2
Adding a Tab Feature
Sheet Metal > Base Flange/Tab 
CommandManager > Sketch > Line
